Owner's Manual
Figure 1
USB35A
12v
USB
Charging /
3.5mm
Aux Input
Tools Needed For Installation
Drill
Unibit or
1"
Hole saw
Wire Crimpers / Strippers
Multi Meter
Figure 2
Figure 3
1) Find a suitable mounting location for USB/AUX unit. Make sure you have at least 2.5"
of
clearance behind
your mounting location. (usually the glove box
is
the best location)
2) Drill a
1"
hole. (Fig 1) Feed the wires through the hole from the front and put USS/AUX
in
the hole. (Fig 2)
Tighten nut on back side. (Fig 3)
3.
With your Multi Meter find a constant or accessory 12volt power source.
4.
Attach the C
T'
tap as shown above, then plug
in
the red/power wire from the
USS/ AUX input.
5. Attach the black/ground wire to a metal location under the dash.
WCli===II
<~
CORPORATE:
SSV
WORKS, 201 N. Rice Ave Suite A Oxnard,CA
93030
WEB:
www
.SSVworks.com