Technical Specs

V1.01
ST Electronics (Satcom & Sensor Systems) Pte Ltd
ST Engineering Hub, 1 Ang Mo Kio Electronics Park Road, #06-02, Singapore 567710
Tel: [phone] Fax: [phone]
Website: www.agilsense.com ( Regn. No.: 199103901W )
Federal Communication Commission Interference
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two condions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operaon.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protecon against harmful interference in a
residenal installaon. This equipment generates, uses and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instrucons, may cause harmful interference to radio communicaons.
However, there is no guarantee that interference will not occur in a parcular installaon. If this equipment does
cause harmful interference to radio or television recepon, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separaon between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Cauon: Any changes or modicaons not expressly approved by the party responsible for compliance could
void the user's authority to operate this equipment.
This transmier must not be co-located or operang in conjuncon with any other antenna or transmier.
Radiaon Exposure Statement:
This equipment complies with FCC radiaon exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator & your body.
This device is intended only for OEM integrators under the following condions:
The antenna must be installed such that 20 cm is maintained between the antenna and users, and
The transmier module may not be co-located with any other transmier or antenna.
As long as 2 condions above are met, further transmier test will not be required. However, the OEM integrator is sll re-
sponsible for tesng their end-product for any addional compliance requirements required with this module installed
IMPORTANT NOTE: In the event that these condions can not be met (for example certain laptop conguraons or co-
locaon with another transmier), then the FCC authorizaon is no longer considered valid and the FCC ID can not be used
on the nal product. In these circumstances, the OEM integrator will be responsible for re-evaluang the end product
(including the transmier) and obtaining a separate FCC authorizaon.