Operating Instructions

15
Using a warm, damp, non abrasive cloth, wipe down the control
panel, handles, glass, stainless steel and enamel surfaces.
Normal stains can be removed by wiping them with a clean cloth
soaked in soapy water before the spill becomes cold or dries up.
More stubborn stains can be removed by soaking them in hot
soapy water. Mild detergents may be used safely on all the
exterior surfaces. Never use oven cleaners, caustic or abrasive
cleaners on any exterior surfaces.
When cleaning surfaces which have a brushed stainless steel finish, take care to wipe in the
same direction as the grain.
After cleaning make sure that all surfaces are rinsed and wiped down with a clean soft cloth.
•
•
•
•
•
Maintenance
Cleaning The Exterior
Maintaining The Shelf Guides
Undo the shelf locking
screw as shown in the
magnified inset.
Remove the shelf guide
by carefully pulling the
guide out of the two
holes in the side wall
first, and then out of the
two holes in the back
wall.
The two shelf guides on the side walls are easily removable for cleaning.
To replace the guide, push the two prongs back
into the holes in the rear wall, then the two holes
in the side wall. To replace the locking screw, you
may need to lift the shelf guide and catalytic liner
slightly up to align with the hole in the side wall.
First undo
locking screw
Pull out from
side wall
Pull out from
rear wall
Changing The Telescopic Slide Position
You can change the level of the telescopic sliders to allow
for deeper baking dishes.
First remove the shelf guides as explained above. Looking
at the rear of the shelf guide, you will see two small brackets
which secure the sliders. Lay the shelf guide down, undo
the nuts to remove the brackets. The telescopic slider will be
released.
Move the slider to a different level, then replace the
brackets and nuts. Ensure when replacing the slider that the
end of the slider is flush with the shelf guide, and the vertical
tabs point upwards when the shelf guide is back rack is in
position.
Slider ush
with shelf
guide
To maintain telescopic slides operating smoothly they must be periodically lubricated with a “food
safe” grease such as ‘HUSKEY HVS-100 Silicone Grease’ or equivalent. Siezed slides will not be
covered under the manufacturer’s warranty.
oven_inb_care.indd 15 25/02/2008 15:22:38