USB 3.0 2-Port PCI Express Card User Manual Ver. 1.00 All brand names and trademarks are properties of their respective owners.
Features Fully compliant with PCI Express Base Specification Revision 2.0 Single-lane (x1) PCI Express throughput rates up to 5 Gbps Compliant with Universal Serial Bus 3.0 specification Revision 1.0 Supports simultaneous operation of multiple USB 3.0, USB 2.0 and USB 1.1 devices Supports the following speed data rates as follows: Low-speed (1.
One available PCI Express slot (Recommend PCI Express 2.0) Package Contents 1 x USB 3.0 2-Port PCI Express Card 1 x Driver CD 1 x User Manual Note: Contents may vary depending on country/market.
Hardware Installation 1. Turn Off the power to your computer. 2. Unplug the power cord and remove your computer’s cover. 3. Remove the slot bracket from an available PCIe slot. 4. To install the card, carefully align the card’s bus connector with the selected PCIe slot on the motherboard. Push the board down firmly. 5. Replace the slot bracket’s holding screw to secure the card. 6. Replace the computer cover and reconnect the power cord. Driver Installation For Windows® XP/Vista/7 (32/64 bit) 1.
To Verify Driver Installation Click on the “Device Manager” tab in System Properties, which you access from the Windows Control Panel. You should see a “NEC Electronics USB 3.0 Host Controller” and a “NEC Electronics USB 3.0 Root Hub” under the “Universal Serial Bus controllers” item.
