User's Manual

January
2016 DocID0xxxxx Rev 0.17
This is preliminary information on a new product now in development or undergoing evaluation. Details are subject to change
without notice. www.st.com
7 Regulatory compliance
7.1 FCC certification
This module has been tested and found to comply with the FCC part 15 rules. These limits are
designed to provide reasonable protection against harmful interference in approved
installations. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference may not occur in a particular installation.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
1 This device may not cause harmful interference,
and
2 this device must accept any interference received, including interference that may cause
undesired operation.
Modifications or changes to this equipment not expressly approved by STMicroelectronics
may render void the user's authority to operate this equipment.
The safe user distance, for RF Exposure, is ≥ 5mm (in compliance with 447498 D01 General
RF Exposure Guidance v06).
Modular approval
FCC ID: S9NSPBT30DP2
In accordance with FCC part 15, the SPBT3.0DP2 is listed as a modular transmitter device.
This module is evaluated for stand-alone use only. Finished products incorporating multiple
transmitters must comply with colocation and RF exposure requirements in accordance with
FCC multi-transmitter product procedures. Collocated transmitters operating in portable RF
Exposure conditions (e.g. <20 cm from persons including but not limited to body worn and
hand held devices) may require separate approval.
7.1.1 Labeling instructions
When integrating the SPBT3.0DP2 into the final product, the OEM must ensure that the FCC
labeling requirements are satisfied. A statement must be included on the exterior of the final
product which indicates the product includes a certified module. The label should state the
following (or similar wording that conveys the same meaning):
Contains FCC ID: S9NSPBT30DP2
OR
This product contains FCC ID: S9NSPBT30DP2
The OEM must include the following statements on the exterior of the final product unless
the product is too small (e.g. less than 4 x 4 inches)This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions:
1 this device may not cause harmful interference, and
2 this device must accept any interference received, including any interference that may
cause undesired operation.