User's Manual

February 2017
DocID0xxxxx Rev 0.xx 23/27
This is preliminary information on a new product now in development or undergoing evaluation. Details are subject to change
without notice. ww w.st.com
6.4 Labeling instructions
When integrating SPSGPE-915 into a finished product, the OEM must ensure that FCC labeling
requirements are satisfied. A statement must be placed over the finished product to indicate it includes a
certified module. The label should state the following (or similar wording that conveys the same meaning):
Contains FCC ID: S9NSPSGPE
OR
This product contains FCC ID: S9NSPSGPE
The OEM must place the following statements over the finished product unless it is too small (e.g. less
than 4 x 4 inches):
This device complies with Part 15 of FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including any interference that may cause
undesired operation.
When integrating SPSGPE-915 into a finished product, the OEM must ensure that IC labeling
requirements are satisfied. A statement must be placed over the finished product to indicate it includes a
certified module. The label should state the following (or similar wording that conveys the same meaning):
Contains IC ID: 8976C-SPSGPE
OR
This product contains IC ID: 8976C-SPSGPE
The OEM must place the following statements over the finished product unless it is too small (e.g. less
than 4 x 4 inches):
This device complies with RSS-247 of IC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including any interference that may cause
undesired operation.