User's Manual

SPZB260C-PRO / SPZB260A-PRO
8/10
Appendix A - FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
− Reorient or relocate the receiving antenna
− Increase the separation between the equipment and receiver
− Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected
Consult the dealer or an experienced radio/TV technician for help
Antenna
Our module type SPZB260C-PRO / SPZB260A-PRO is for OEM integrations only. The end-user product will be
professionally installed in such a manner that only the authorized antennas are used.
Caution
Any changes or modifications not expressed approved by the part responsible for compliance could cause the
module to cease to comply with FCC rules part 15, and thus void the user’s authority to operate the equipment.
.
A.1 - LABEL INSTRUCTION
INSTRUCTION MANUAL FOR FCC ID LABELING
Module type : ZigBee modules SPZB260C-PRO / SPZB260A-PRO
FCC-ID : S9NZB260B
This intends to inform you how to specify the FCC ID of our ZigBee modules SPZB260C-PRO /
SPZB260A-PRO in your final product.
Based on the Public Notice from FCC, the product into which our transmitter module is installed must
display a label referring to the enclosed module.
The label should use wording such as “Contains Transmitter module FCC ID: S9NZB260B or “Contains
FCC ID: S9NZB260B , any similar wording that expressed the same meaning may be use.
It shows an example below
Contains FCC ID: S9NZB260B