Datasheet

Electrical specifications VN750-E
16/38 Doc ID 10891 Rev 7
Figure 24. Application schematic
2.5 GND protection network against reverse battery
2.5.1 Solution 1: resistor in the ground line (R
GND
only)
This can be used with any type of load.
The following is an indication on how to size the R
GND
resistor.
1. R
GND
≤ 600mV / (I
S(on)max
).
2. R
GND
≥ (−V
CC
) / (-I
GND
)
where -I
GND
is the DC reverse ground pin current and can be found in the absolute
maximum rating section of the device datasheet.
Power Dissipation in R
GND
(when V
CC
<0: during reverse battery situations) is:
P
D
= (-V
CC
)
2
/R
GND
This resistor can be shared amongst several different HSDs. Please note that the value of
this resistor should be calculated with formula (1) where I
S(on)max
becomes the sum of the
maximum on-state currents of the different devices.
Please note that if the microprocessor ground is not shared by the device ground then the
R
GND
produces a shift (I
S(on)max
* R
GND
) in the input thresholds and the status output
values. This shift varies depending on how many devices are ON in case of several high
side drivers sharing the same R
GND
.
If the calculated power dissipation leads to a large resistor or several devices have to share
the same resistor then ST suggests to utilize Solution 2 (2.5.2: Solution 2: diode (DGND) in
the ground line).
9
&&
*1'
287387
'
*1'
5
*1'
'
OG
 &
9
5
SURW
9
*1'
67$786
,1387
9
5
SURW
*$3*5,