STABER DRYER HXD2304E HXD2304G Operator’s Manual Operation/Maintenance/Parts Part Number 828213 Printed in USA
DRYER SAFETY Note the importance of safety. You and anyone else using or maintaining this dryer are strongly urged to read this manual, especially all of the safety instructions. Always read and obey all safety instructions. This symbol is for any safety alert. This symbol will alert you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.
• • • • • • • • • • • • • solvent, or which is saturated with flammable liquids or solids, should not be placed in the dryer, until all traces of these flammable liquids or solids and their fumes have been removed. There are many highly flammable items used in homes, such as: acetone, denatured alcohol, gasoline, kerosene, some liquid household cleaners, some spot removers, turpentine, waxes and wax removers.
CHECKING YOUR VENT 4 You must properly install and vent your dryer to achieve maximum drying efficiency and to also shorten drying times. To avoid blocking the flow of combustion and ventilation air, use the minimum recommended installation clearances (found in your Installation Instructions). Refer to your Installation Instructions for more information. WARNING: Fire Hazard • Use a heavy metal vent. • Do not use a metal foil vent. • Do not use a plastic vent.
TO RESTART YOUR DRYER 1 Close the door. 2 Select a new cycle and temperature (if desired). 3 Press the START button. LOADING • Place only one wash load in the dryer at a time. • Load clothes loosely into the dryer which allows space for clothes to tumble freely. • Mixed loads of heavy and lightweight clothes will dry differently. Lightweight clothes will dry, while heavy clothes may be damp. • Add one or more similar items to the dryer when only one or two articles need drying.
As needed cleaning: Laundry detergent and fabric softener residue can build up on the lint filter. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. If lint falls off the filter it is probably clogged. Clean the lint filter with a nylon brush about every six months, or more frequently if it becomes clogged due to a residue buildup. To wash 1 Use your fingers to roll lint off filter. 2 Use hot water and wet both sides of lint filter.
Staber Industries will not be responsible for: a. Service calls to: a. Correct the installation of the dryer, including venting. Heavy 4 inch (10.2 cm) metal exhaust vent must be used. Refer to the venting section of this manual and your Installation Instructions. b. Instruct you how to use the dryer. c. Correct wiring, replace fuses, or reset circuit breakers. b.
Staber Industries, Inc. 4800 Homer Ohio Lane Groveport, Ohio 43125 614.548.0098 www.staber.com Product information and specifications are shown herein as of the time of printing. Staber Industries, Inc. reserves the right to change product specifications, designs and standard equipment without notice and without incurring obligation.