User manual

If a tolerance has been exceeded when performing the vertical check, the laser can
be re-adjusted as follows. Switch the laser off. To go to Adjustment mode, hold
down button (4a) first. Additionally press button (3). as soon as the y LED illumina-
tes, release button (4a).
The Z LED now flashes rapidly.
The laser can now be adjusted in the Z-axis.
The laser is correctly adjusted when the laser dot is precisely centred between
Points 1 and 3 for the vertical check. Adjust the dot's height using buttons (17) and
(18) on the remote control until it is precisely between Points 1 and 3.
Adjustment - Vertical
The laser is now adjusted again. Pressing button (14) on the remote control saves
the settings. If you do not wish to save the setting, exit Adjustment mode without
saving by pressing the button (3) on the laser. The old setting is then kept
unchanged.
Saving the adjustment
Replacing the
batteries
Remote control
3
3
4a
17
18
19
Rotation laser
Full batteries must be used when using the adjustment function!
Mignon
AA
LR6
Mono, D , LR20
7
1.
2.
Unfasten the catch on
the battery compartment
cover: remove the cover
and the batteries. Insert
new batteries following
the instructions in the
battery compartment.
Only use 1.5V mono cells
(size D)!
Tip:
Remove the batteries if the unit
will not be used for a long period !
Suitable batteries
can also be used.