User manual

Operating status display and error messages via the LEDs
Illuminated green LED
-> The laser levels itself automatically
-> laser in operation
-> laser in operation
-> battery voltage very low
-> battery replacement required imminently
The red LEDs (5a) next to the corresponding buttons show the operating mode
selected.
-> Battery voltage very low
-> The unit is inclined too much
+ is outside the self-levelling range
+ the laser cannot level itself automatically
Illuminated green LED +
laser beam flashing
Illuminated red LED
Flashing red LED
+ laser beam flashing
-> The temperature in the unit is over 50°C / or 122°F
-> The laser diodes have been switched off to protect
against overheating
-> Place the unit in the shade to be able to continue
working.
-> The laser is not working
The red + green
LEDs flash
+ the laser beam
cannot be seen
-> The unit is inclined too much
+ is outside the self-levelling range
+ the laser cannot level itself automatically
Flashing green LED
+ laser beam flashing
-> The laser levels itself automatically
-> Battery voltage very low
-> Battery replacement required imminently
Illuminated red LED
+ laser beam flashing
NB:
In Class II laser equipment, your eyes
are protected from accidental, short-
term exposure to the laser beam by
the lid-closing reflex and/or the reflex
reaction to turn one's head. This
equipment can therefore be used
without additional protective measu-
res. Nevertheless, you should not look
directly into the laser beam.
The laser goggles enclosed with these
units are not safety goggles. They are desi-
gned to make the laser light easier to see.
Do not let the unit fall into children's
hands!
EN 60825-1 : 03 10
Note:
here is the declaration
for Israel necessary in
hebrew language !