L1 L2 B1 B2 105 mm 115 mm 59 mm C1 570 gr -> 17282 9 C2 -> 17282
A 2a 4 1a 2b 5 7 3 1b 8 6
D1 D2 2m E1 Δ1 = X1 - Y1 Δ2 = X2 - Y2 Δ3 = X3 - Y3 E2 E3
D3 F1 1 mm 2m F2 F3 s F4 F5 > 5m > 16 2 ft 3
GB Operating instructions The STABILA-LAX-200 is an easy-to-use crossed line laser. It is self-levelling in the range ± 4.5° and enables levels to be determined quickly and accurately. The vertically and horizontally projected laser lines provide exact alignment / working . The different parts of this set enable a tripod or a long support pole to be constructed to suspend the instrument between the floor and the ceiling.
NB: In Class II laser equipment, your eyes are protected from accidental, shortterm exposure to the laser beam by the lid-closing reflex and/or the reflex reaction to turn one's head. This equipment Do not let the unit can therefore be used without additiofall into children's nal protective measures. Nevertheless, EN 60825-1 : 03 10 hands! you should not look directly into the The laser goggles enclosed with these units laser beam. are not safety goggles.
Setting the type of line: The vertical line, horizontal line and the crossed laser line can be activated in succession by using the selector switch (1a) The laser will flash if the inclination is too great. -> The unit is inclined too much laser beam + is outside the self-levelling range flashing + the laser cannot level itself automatically Operating mode without levelling function The on/off switch (1b) is switched off In this mode the LAX 200 is only switched on or off with the selector switch (1a).
Horizontal checking 1. Horizontal checking - Line level Two parallel wall surfaces at least 5 m apart are required for the horizontal check. F1 1. Set the LAX-200 on a smooth level surface or on the tripod with the front facing the wall. 2. Switch the unit on. F2 3. Mark the position of the visible laser line cross on the wall A (point 1). F3 4. Turn the complete unit 180° without altering the height of the laser. 5. Mark the position of the visible laser line cross on the wall B (point 2). F4 6.
Δ1 = X1 - Y1 Δ2 = X2 - Y2 Δ3 = X3 - Y3 The following applies for the differences: Δges 1 = Δ1 - Δ2 Δges 3 = Δ3 - Δ2 S ± 2mm 5m 2,0 mm 7,5m 3,0 mm 10m 4,0mm ± 2mm When calculating, always take note of the preceding sign! Replacing the batteries Δges 1 or Δges 2 Mignon, AA , LR6 Slide the battery cover (4) in the direction of the arrow and insert new batteries in accordance with the symbols in the battery compartment. 3. 3 x 1,5V alkaline mignoncells, size AA, LR6 1. 2.
Care and maintenance • Dirty lens glass on the beam emitter detracts from the quality of the beam. It should be cleaned with a soft cloth. • Clean the laser unit with a damp cloth. Do not spray or immerse the unit! Do not use solvents or thinners! Like any precision instrument, handle the LAX-200 crossed line laser carefully and cautiously. Technical data Laser type: Output: Self-levelling range: Red diode laser, pulsed line-laser wavelength 630-660 nm < 1 mW, Laser Class 2 to EN 60825-1:03-10 ca.