User manual

Control elements and connections
Important note: Some of the menu items and functions described within these operating
instructions refer to the usage of the set with several cameras (e.g. quad function)!
Monitor (front)
1 Cam key
Manual switchover between the available cameras and deactivation of automatic switchover.
2 Quad key
Activation of Quad function (simultaneous display
of all available cameras on the monitor). By
pressing the key once again, automatic switchover
(every 5 sec.) between the available cameras is
activated.
3 SCAN key
Activation of Scan function (the display shows
Enter Scan Mode, the display is switched off and
a green LED lights up on the bottom left corner
of the monitor). In Scan mode, the monitor
permanently monitors the available or all available
camera(s). Upon movement detection, an alarm
tone sounds and the corresponding camera image is shown for approx. ca. 8 sec.
The Scan function is deactivated by actuating the Scan key, the green LED turns off.
4 Zoom key
Activation/deactivation of zoom function (double zoom, the display shows
).The joystick is
used to move the visible image section.
Note: This function is not available with the HD image resolution!
5 Delete key
For deleting recorded files from the SD memory card (in playback mode).
6 Menu key
For opening/exiting the main menu.
7 Joystick
Switchover to playback mode from view mode.
In playback mode, control of the function Play/ Pause, Stop, fast forward, fast backward.
In menu mode, navigation through and modification of the individual settings in system menu.
8 LC display
Display of the camera image(s) and or on-screen menu.
Monitor (on top)
9 Motion key
Activation/deactivation of the automatic recording
mode (activation through PIR sensor or Video
Motion Detection, recording time either 15, 30, or
60 sec.)
28