User manual

31
The power supply unit marked with OUTPUT 5 V DC/2 A should be used only for the monitor!
Plug the power supply unit into a socket (230 V) and connect the plug to the 5 V DC IN socket
at the back side of the monitor. The power-on indicator lights up green.
Adjust the antenna vertically upwards.
Mounting and connecting the camera
Important information: Consider the following when selecting the mounting position of the
camera:
Area of coverage: Angle (approx. 60°) and range (approx. 5 m) of the motion detector.
Lighting conditions: The camera should not be orientated towards direct, strong light
sources/sunlight, since overexposed images may result.
Power supply: The camera's power supply unit must not be exposed to the weather in the open!
The plug-in connection of the power supply cable must be protected for preventing any moisture
from entering.
Mounting: Protection type IP 65 allows devices to be installed in the open. However, the camera
should nevertheless be installed in a well protected place. Make sure that the base material for
mounting is stable and does not give rise to strong vibrations and/or falls.
First, install the monitor and camera only provisionally and check whether the desired monitored
area is completely covered and a reliable radio transmission is assured: Prior to drilling the holes
for the camera support, check and optimize the arrangement of the system, if necessary! Make
sure that no cables or conducts are placed in the wall which may be damaged when drilling!
Mark the desired position for the three drilling holes of the fixing screws by using the camera
support as drilling jig.
Drill the three mounting holes and fix the support
using screws which are suitable for the respective
base material.
Screw the antenna on the antenna jack.
Afterwards, attach the camera to the support.
Carefully, align camera and antenna.
The power supply unit marked with OUTPUT 9
V DC/0.6 A should be used only for the camera!
Plug the power supply unit into a socket (230 V) and connect the plug to the DC IN socket of the
camera.
Establishing the connection between monitor and camera
Camera and monitor are already coupled ex works such that the monitor display shows the image
taken as soon as monitor and camera are switched on.
Note: However, each additional camera (available as option) must be individually coupled o the
monitor (see menu item Pairing).
cable outlet