User manual

34
Scan mode
Note: In Scan mode, the display is dark and the speaker is muted.
For activating the Scan function, press the Scan key (the display shows Enter Scan Mode and
a green control LED lights up on the bottom left). As soon as an active camera detects a movement,
display and speaker are activated for 15 sec. (in this case, the green control LED is not illuminated).
Afterwards the system returns to Scan mode again.
For deactivating the Scan function, press the Scan key (the green control LED turns off), the
system switches over to automatic camera change.
Recording on SD memory card
The monitor is equipped with a slot for commercially available SD memory cards for data storage.
If you wish to record the camera shots, insert a SD memory card of max. 64 GB into the memory
card slot. Format your SD memory card prior to first usage. Make sure that the memory card is
not write-protected.
Depending on your needs, recording can be triggered manually, through the PIR motion detector
of the camera, through automatic Video Motion Detection or through the timer (specified recording
time, can be individually programmed for each day of the week).
Triggering of recording through motion detector
By pressing the Motion key, the automatic recording mode is activated ( is shown on the
display): As soon as an active camera detects a movement, recording is automatically started,
l REC is shown on the display. When the recording time (15, 30, or 60 sec., see menu item
Record) has elapsed, l REC disappears from the display.
By pressing the Motion key once again, the function Automatic recording
is deactivated (
disappears).
Note: If recording is to be triggered exclusively through the camera's motion detector, the VMD
function (see menu item Detect) has to be deactivated (OFF) !
Triggering of recording through Video Motion Detection
First activate the VMD function in the main menu (see menu item Detect)!
By pressing the Motion key, the automatic recording mode is activated (
is shown on the
display): As soon as an active camera detects a movement, recording is automatically started,
l REC is shown on the display. When the recording time (15, 30, or 60 sec., see menu item
Record) has elapsed, l REC disappears from the display.
By pressing the Motion key one again, the function Automatic recording is deactivated (
dis-
appears).
Manual triggering of recording
By pressing the REC key, recording is started l REC is shown on the display), by pressing the
key once again, recording is stopped ( l REC disappears).
Programmed recording
Recording can automatically be started every day at a certain time. Use the menu Record to
specify the individual start/stop time for each individual day of the week.
Recording in Quad mode
In Quad mode (simultaneous indication of up to four cameras), each full screen of the cameras
is recorded. As is the case with the recording of a full screen indication, this recording is also
triggered manually or automatically. Whether and how recording is to be started (through PIR
sensor, VDM, timer or manually) can be individually specified for each connected camera.