User manual

-15-

5.3.1 Record Time

Recorded video is sliced into smaller video files for better storage management. Default value is 5

Minutes for each file.

1. Press [ENTER] button to start

2. Use [UP / DOWN / LEFT / RIGHT] button to select file length

3. Press [ENTER] button to confirm or [MENU] button to exit

5.3.2 Date Stamp

Enable/disable “Date/Time” stamp on Live View screen. Default is “ON”, date and

time are shown at the lower left corner of each camera channel.

To change the setting:

1. Press [ENTER] button to go into “Date Stamp” menu. Default value in “ON”

marked with RED tick under the ON label

2. Use [LEFT / RIGHT] button to select turn “ON” or “OFF” date stamp in Live

View, press [ENTER] again to confirm changes

3. Press [MENU] to exit

5.3.3 Loop Recording

Set to enable/disable HDD video loop recording. When the internal hard drive is full

during video recording, the NVR will delete oldest files to release HDD space.

1. Press [ENTER] button to go into “Loop Recording” menu. Default value in

“ON” marked with RED tick under the ON label

Default duration – 5 minutes

Change duration and press [ENTER] to confirm

Default status – display time

stamp in Live View

Select [OFF] to disable time stamp in Live

View, press [ENTER] to confirm