Installation Instructions

20
Where a Field Seam Travels
Under a Wall Flashing.
Field Seam at Vertical Change
Where a eld seam makes a radical bend (turns up a wall or
down over a perimeter edge), a six-inch (6") wide by twelve
inch (12") long piece of Tape Flashing is to be adhered over
the seam. Round the corners of the Tape Flashing. Follow
standard ashing procedures; install the ashing so that half of
the ashing is on either side of the area to be covered. Finally,
use Rubber Caulk to seal all edges. (Figure 17C)