USER GUIDE MULTI-CHANNEL STEREO MIXER S MIX 4M2S UD
FEATURES 4 mono input channels and 2 stereo input channels. Frequency EQ on each input channel. Low-noise mic pre-amp on microphone inputs. Low cut filter for the mono channel. 10dB attenuator switch on stereo channel. One AUX output channel, one AUX input channel. Individual stereo play input and record output channel. Stereo monitor output and headphones output channel. +48V phantom power for condenser microphones. Balanced main outputs L+R DSP effects processor, providing 16 kinds of effects.
13. +48V Phantom Power Switch and Indicator This switch is used for turning on or off +48V phantom power. +48V voltage will be present on the socket of each microphone input channel when this switch is pressed down. Important: set all channel faders to minimum before turning this switch on or off. Do not plug or unplug a microphone after this switch has been turned on. Do not turn on the switch when a dynamic microphone is in use. STEREO CHANNEL SECTION 1.
MASTER CONTROL SECTION 1. AUX RET These two unbalanced 2-pole phone jacks are used for stereo AUX line input (the rated input level is -10dB). If the signal source is mono please plug into the left channel socket only (L/MONO). 2. AUX SEND This jack socket sends the signals to an auxiliary source. 3. PHONES This jack socket sends the signals from main output or tape player to the headphones. 4. REC OUT These two RCA sockets send stereo signals for recording purposes. 5.
MASTER CONTROL SECTION 19 13 20 12 15 14 16 11 18 11. MAIN OUTPUT CONTROL This slide fader is used for adjusting the final output level sent to the main output sockets. 12. Output Level Meter This level meter Indicates the signal level of the stereo master output. 13. Power Indicator This LED indicates whether this unit is switched on or not. 14. AUX RET Use this knob to control the signal level sent from AUX return to the stereo main bus. 15.
CONNECTION CABLES/EFFECTS TABLE CONNECTION CABLES BALANCED OUTPUTS EFFECTS TABLE R 6
SPECIFICATIONS Balanced 7
IMPORTANT SAFETY INSTRUCTIONS READ AND KEEP THESE INSTRUCTIONS. HEED ALL WARNINGS. • If, after you have followed the instructions outlined above, this device fails to function, please contact your dealer. Under no circumstances should this device be opened. Leave all servicing to qualified personnel. • Electrical appliances must never be used in conditions of high humidity or heat. To prevent any risk of fire or electric shock, never spill or splash liquids on this device.