Operation Manual

2
3
1. L/MONO - R These are two unbalanced 2-pole phone
jacks for stereo line input. The input level range is -10dB. If
the source signal is mono please use the left channel.
2. -10dB Press this switch to attenuate the line input signal
-10dB to  t the high level signal source.
3. HI Use this control to raise or lower the high frequencies.
Max adjustment range: 15KHz ±15dB.
4. MID This control determines the level of mid frequencies
in the output signal.
5. LOW Use this control to raise or lower the low
frequencies. Max adjustment range: 80Hz ±15dB.
6. AUX Use this knob to control the signal level sent from
each channel to the AUX bus. It is set before the channel
fader, so it is not dependent on the fader position.
7. BAL The BAL control for the stereo channels determines
the relative volume of the left and right input signals.
8. LEVEL This rotary fader controls the output level feed to
the main bus from the input channel.
13. +48V Phantom Power Switch and Indicator
This switch is used for turning on or off +48V phantom
power. +48V voltage will be present on the socket of each
microphone input channel when this switch is pressed down.
Important: set all channel faders to minimum before
turning this switch on or off. Do not plug or unplug a
microphone after this switch has been turned on. Do not
turn on the switch when a dynamic microphone is in use.
MONO CHANNEL SECTION
STEREO CHANNEL SECTION