Owner's manual

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: [phone]
INSTALLATION INSTRUCTIONS FOR 2014 CHEVY SS CATBACK
Thanks for purchasing our Stainless Works product for your 2014 Chevy SS 6.2L
Catback Exhaust. We have gone to great pains to make sure that our exhaust systems fit
and sound great. Please follow these steps to ensure that your installation goes as
planned.
1. Stainless Works recommends the use of Hi-Temp RTV sensor safe silicon gasket
maker as an option to or in conjunction with the use of factory gaskets. The
recommended Oxygen Sensor Safe RTV is either Valco All-in-One Aluminum or
Permatex Copper P/N 101BR available at NAPA, Autozone and other retailers.
2. Disconnect the battery before starting work on the exhaust system for your
vehicle. Reconnect the battery when the job is completed.
3. Your exhaust system can be installed by a weekend warrior but the use of a lift is
recommended for ease of installation. If using a jack, the vehicle must be placed
on a level hard surface and jack stands are required for safety reasons.
4. You will assemble the components together as specified below, but only snug the
clamps as you move along from front to back. When placing the X-pipe into
position, make certain that you push it fully forward and level it in with the
vehicle. After aligning all the components in the vehicle, you will tighten all the
clamps working from front to back of the vehicle.
5. Raise and support vehicle.
6. Remove ball clamps at the front of the mufflers and remove mufflers.
7. Remove (4) 10 mm bolts from cross brace and remove.
8. Remove tailpipes from the rubber hangers.
9. Unbolt (4) 10 mm nuts, 2 per side from exhaust connection flanges behind the
OEM catalytic converters.
10. Remove exhaust from the vehicle.