Installation Guide

This end of the molding MUST be placed
on the lower of the two surfaces.
Technical Information
3-IN-1 TRIM MOLDING
Applications
Installation Instructions
2”
1/4”
13/64”
3-in-1 Trim Molding
The 3-in-1 Trim Molding functions as a Reducer, T-Molding, and End Cap.
Comes with Track and Shim.
Surface Material: High Wear Resistant Aluminum Oxide Laminate
Core Material: PVC
Track - Used to install as Reducer, T-Molding, and End Cap
Material: Cold Roll Steel
Shim - Used to install as T-Molding and End Cap
Material: Standard HDF
ShimTrackTrack Carpet Tap Down Trim
31
in
3/8“
Step 3
Step 2
Step 1
Install the flooring plank. Then place the track 3/8”from the
floor and screw it to the sub-floor using #4x3/4" screws.
Line the molding up with the track and fit one end into
the molding. Using a rubber mallet, tap the molding until it
engages with the track. Use your hand to guide the
molding into the track as you work your way down,
tapping it in, similar to how you would close a zip-loc bag.
Next, go up and down the molding several times, tapping it
all the way into the track. You can use a little more force
once you are sure it is properly engaged in the track.
Sub Floor
Rubber
Mallet
IMPORTANT: Rock molding back & forth to make sure
it is sitting inside the track BEFORE hammering in!
Track
3-in-1 Trim
Molding
If molding wiggles back and forth, it is
NOT set in the track properly and will
be damaged when hammered in!
1 3-in-1 Trim as a REDUCER
1 REDUCER 2 T-MOLDING 3 END CAP
9/16”
3/16”
7/16”
1/8”
9/16”

Summary of content (2 pages)