Installation Guide

Installation Instructions Option 2
Remove existing floor covering from existing tread & riser including all nails and staples down to a
clean, level, dust free surface.
Cut o existing nosing flush with existing riser.
Starting at the bottom of the stairs measure for new riser with Tread Tool (sold separately),
and transfer that mark to new riser and then cut for length. Also cut the new riser to the correct
height which when cut will be flush with the top of the existing tread.
Glue new riser in place with ¼” bead of urethane adhesive. A small brad or pin nail can be placed at
both ends of riser to hold in place while adhesive cures if desired.
Measure existing tread for length with Tread Tool (sold separately), and then transfer that mark to
retread for length to be cut. Cut new retread to correct length. Cut depth of retread to fit existing stair
tread.
After cut is complete apply adhesive to underside of retread using ¼” bead of URETHANE ADHESIVE.
A small brad or pin nail can be placed at left rear and right rear of new retread to hold in place while
adhesive cures. Remove all wet adhesive from finished surface before adhesive cures following
urethane adhesive manufacturer’s instructions.
Repeat this process for each riser and retread working from bottom to top of stairs installing riser,
retread, riser, retread etc. until your new beautiful stairs are complete.
1
2
3
4
5
6
7
8