User manual
Table Of Contents
- Table of Contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 7.1 Switching the device on / off
- 7.2 Operating mode Automatic
- 7.3 Sound control
- 7.4 Operating mode DMX
- 7.5 Operating mode Slave
- 7.6 System settings
- 7.7 Reset to factory default setting
- 7.8 Menu overview
- 7.9 Functions in 2-channel DMX mode
- 7.10 Functions in 5-channel DMX mode
- 7.11 Functions in 8-channel DMX mode
- 7.12 Functions in 10-channel DMX mode
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
3 Features
Special features of the device:
n 2 strobe arrays each with 18 cold white LEDs, 0.5 W each
n Grading laser with two laser diodes
n 2 beam spots each with 192 RGBWA LEDs, 0.12 W each
n 2 UV LEDs, 3 W each
n Control via DMX (4 dierent modes), buttons and display on the unit as well as
the supplied infrared remote control
n 10 preprogrammed automatic shows
n Sound control
n Master / Slave mode
n Key switch secured
For technological reasons, the light output of LEDs decreases over their lifetime. This
eect increases with higher operating temperature. You can extend the service life of
the illuminants by providing adequate ventilation and operating the LEDs with the
lowest possible brightness.
Features
10
All FX Bar
LED eect