User manual
Table Of Contents
- Table of Contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 7.1 Switching the device on / off
- 7.2 Operating mode Automatic
- 7.3 Sound control
- 7.4 Operating mode DMX
- 7.5 Operating mode Slave
- 7.6 System settings
- 7.7 Reset to factory default setting
- 7.8 Menu overview
- 7.9 Functions in 2-channel DMX mode
- 7.10 Functions in 5-channel DMX mode
- 7.11 Functions in 8-channel DMX mode
- 7.12 Functions in 10-channel DMX mode
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
4 Installation
Unpack and check carefully there is no transportation damage before using the unit.
Keep the equipment packaging. To fully protect the product against vibration, dust
and moisture during transportation or storage use the original packaging or your
own packaging material suitable for transport or storage, respectively.
You can install the device standing or hanging. When in use, the device must be
mounted at a solid surface or clamped to an approved truss.
Work from a stable platform whenever you install or move the device or when you
perform any kind of maintenance. Block access under the work area.
DANGER!
Follow the instructions in the chapter titled "Safety Instructions" in the
user manual.
To avoid laser emission, remove the safety key before you start to install
the device.
WARNING!
Stray laser radiation
Inadequately secured additional components may cause stray laser radi‐
ation.
Make sure that all additional components are adequately secured.
WARNING!
Risk of injury caused by falling objects
Make sure that the installation complies with the standards and rules
that apply in your country. Always secure the device with a secondary
safety attachment, such as a safety cable or a safety chain.
NOTICE!
Risk of overheating
The distance between the light output and the illuminated surface must
be more than 2.0 m (78.7 in).
Always ensure sucient ventilation.
The ambient temperature must always be below 40 °C (104 °F).
Installation
All FX Bar
11
LED eect