User manual
Table Of Contents
- Table of Contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 7.1 Switching the device on / off
- 7.2 Operating mode Automatic
- 7.3 Sound control
- 7.4 Operating mode DMX
- 7.5 Operating mode Slave
- 7.6 System settings
- 7.7 Reset to factory default setting
- 7.8 Menu overview
- 7.9 Functions in 2-channel DMX mode
- 7.10 Functions in 5-channel DMX mode
- 7.11 Functions in 8-channel DMX mode
- 7.12 Functions in 10-channel DMX mode
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
5 Starting up
Create all connections while the device is o. Use the shortest possible high-quality
cables for all connections. Take care when running the cables to prevent tripping
hazards.
Connect the DMX input of the device to the DMX output of a DMX controller or
another DMX device. Connect the output of the rst DMX device to the input of the
second one, and so on to form a daisy chain. Always ensure that the output of the
last DMX device in the daisy chain is terminated with a resistor (110 Ω, ¼ W).
The DMX indicator next to the display lights up as soon as a DMX signal is present.
When you congure a group of devices in master/slave mode, the rst unit will con‐
trol the other units for an automatic, sound-activated, synchronized show. This func‐
tion is ideal when you want to start a show immediately. Connect the DMX output of
the master device to the DMX input of the rst slave device. Then connect the DMX
output of the rst slave device to the DMX input of the second slave device and so
on.
Connections in DMX mode
Connections in master/slave mode
Starting up
All FX Bar
13
LED eect