User manual

7 Operating

7.1 Switching the device on / o

1. Verify that all required laser safety precautions have been taken. Make sure

that there is no one in the reach of the laser beam.

2. Insert the safety key into the lock.

3. If not already done, connect the device to the mains.

4. After a few seconds, the fan and the motors start to work. The display shows

the current version number of the device.

The device is operational.

5. Turn the safety key to the ‘ON’ position to turn the laser beam on.

1. Turn the safety key to the ‘OFF’ position to turn the laser beam o and remove

the key. Keep the safety key under control.

2. Disconnect the device from the mains.

7.2 Operating mode Automatic

This setting is only relevant if the device is not controlled via a DMX controller and

not working as slave in a master / slave conguration.

1. Press [MENU] repeatedly until the display shows ‘Aut’ and conrm with

[ENTER].

2. Press [UP] or [DOWN] to select between the automatic programmes

‘Au01’ … ‘Au14’ .

3. Conrm the selection with [ENTER].

The selected automatic programme is played back immediately.

4. Press [ENTER] again to open the settings menu for the programme run speed.

5. Use [UP] or [DOWN ] to set the programme run speed between ‘S 1’

(slow) … ‘S100’ (fast).

6. Conrm the selection with [ENTER].

7. To return to the main menu without making changes, press [MENU].

Switching on

Turning o

Operating

All FX Bar

LED eect