User manual

7.4 Operating mode DMX

This setting is only relevant if the device is controlled via a DMX controller.

1. Press [MENU] repeatedly until the display shows ‘dMX’ and conrm with

[ENTER].

The display shows ‘d 1’ .

2. Press [ENTER] again to open the settings menu for the DMX mode.

3. Press [UP] or [DOWN] to select the desired DMX mode and conrm with

[ENTER].

The following DMX modes are available:

Menu level 2 Description

‘02Ch’ 2-channel mode

‘05Ch’ 5-channel mode

‘08Ch’ 8-channel mode

‘10Ch’ 10-channel mode

5. After conrming the DMX mode, press [UP] or [DOWN] to select a value

between 1 and 512 for the desired DMX address (display shows ‘d 1’ … ‘d512’ )

and conrm the selection with [ENTER].

Make sure that this number matches the conguration of your DMX controller.

The following table shows the respective highest possible DMX address for the

various DMX modes.

Mode Highest possible DMX address

2-channel mode 511

5-channel mode 508

8-channel mode 505

10-channel mode 503

6. To return to the main menu without making changes, press [MENU].

7.5 Operating mode Slave

In this mode, the device exactly follows the operation of the master that it is con‐

nected to.

1. Press [MENU] repeatedly until the display shows ‘SLA’ and conrm with

[ENTER].

The display shows ‘SLAV’ . The Slave mode is activated.

2. To return to the main menu without making changes, press [MENU].

Setting the DMX mode

Setting the DMX address

Operating

All FX Bar

LED eect