User manual
Table Of Contents
- Table of Contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 7.1 Switching the device on / off
- 7.2 Operating mode Automatic
- 7.3 Sound control
- 7.4 Operating mode DMX
- 7.5 Operating mode Slave
- 7.6 System settings
- 7.7 Reset to factory default setting
- 7.8 Menu overview
- 7.9 Functions in 2-channel DMX mode
- 7.10 Functions in 5-channel DMX mode
- 7.11 Functions in 8-channel DMX mode
- 7.12 Functions in 10-channel DMX mode
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
9 Plug and connection assignments
This chapter will help you select the right cables and plugs to connect your valuable
equipment so that a perfect light experience is guaranteed.
Please take our tips, because especially in ‘Sound & Light’ caution is indicated: Even if
a plug ts into a socket, the result of an incorrect connection may be a destroyed
DMX controller, a short circuit or ‘just’ a not working light show!
The unit oers a 3-pin XLR socket for DMX output and a 3-pin XLR plug for DMX
input. Please refer to the drawing and table below for the pin assignment of a suit‐
able XLR plug.
Pin Conguration
1 Ground, shielding
2 Signal inverted (DMX–, ‘cold signal’)
3 Signal (DMX+, ‘hot signal’)
Introduction
DMX connections
Plug and connection assignments
All FX Bar
33
LED eect