Data Sheet

Thomann GmbH

Hans-Thomann-Str. 1 • 96138 Burgebrach

Germany • www.thomann.de

DocID: 171852_404343_08.02.19

The C-clamp is intended for use on trusses with a tube diameter of 30 mm

to a maximum of 52 mm. Use the device only as described. Any other use

or use under other operating conditions is considered to be improper and

may result in personal injury or property damage. No liability will be as-

sumed for damages resulting from improper use.

Ensure that plastic bags, packaging, etc. are not within reach of

babies and young children. Choking hazard! Ensure that children

do not detach any small parts (e.g. knobs or the like) from the unit.

They could swallow the pieces and choke! Never let children unattended

use electrical devices.

Die tightening power of the C-clamp-bolt on the truss should be

about 20N. Do not keep using the C-clamp if it shows damages.

Check every 30 days, whether the C-clamp is still sitting rmly on the

truss. Tighten the screws again rmly if necessary. Make sure that the

C-clamp is not exposed to moisture for a longer period of time.

For the transport and protective packaging, environmentally

friendly materials have been chosen that can be supplied to normal

recycling. Ensure that plastic bags, packaging, etc. are properly dis-

posed of. Do not just dispose of these materials with your normal house-

hold waste, but make sure that they are collected for recycling. Please fol-

low the notes and markings on the packaging.

9 C-clamp for stage lighting

9 50kg max. working load

9 175mm × 90mm × 25mm

9 also available in black

C-Clamp

50kg working load

Construction and mounting:

The C- clamp is made of 25mm × 6mm cold-rolled steel.

The truss protection spring is attached by two iron rivets at the C-clamp. A wing nut M10 x 25 is used to secure the

C-clamp to the truss.

For fastening of the lighting xture, a screw M10 × 35 is used with appropriate nut M10, a 10 mm at washer and a 10 mm

spring washer.

PAGE 1
C-Clamp 50 kg working load 99 C-clamp for stage lighting 99 50 kg max. working load 99 175 mm × 90 mm × 25 mm 99 also available in black Construction and mounting: The C- clamp is made of 25 mm × 6 mm cold-rolled steel. The truss protection spring is attached by two iron rivets at the C-clamp. A wing nut M10 x 25 is used to secure the C-clamp to the truss. For fastening of the lighting fixture, a screw M10 × 35 is used with appropriate nut M10, a 10 mm flat washer and a 10 mm spring washer.