User manual

Press [M]. Press one of the arrow buttons repeatedly until the display shows ‘LINE’ . Press [OK].

Press one of the arrow buttons repeatedly until the display shows ‘MA’ . Press [OK]. Now you

can select one of the preprogrammed automatic shows. Use the arrow buttons to select a

value between 1 and 42 (display shows ‘P-01’ … ‘P-42’ ).

The auto show can only be activated on the device that works as master.

This setting is only relevant if the device is not controlled via DMX. The device can operate in

stand-alone mode or control connected devices of the same type, that must be congured as

slaves. When the display shows the desired value press [OK] to conrm the selection and then

[M] to return to the parent menu. To return to the parent menu without making changes, press

[M].

Press [M]. Press one of the arrow buttons repeatedly until the display shows ‘LINE’ . Press [OK].

Press one of the arrow buttons repeatedly until the display shows ‘SL’ . Press [OK]. Now you can

set the number for the device via which it is addressed by the master as a slave. Use the arrow

buttons to select a value between 1 and 512 (display shows ‘A001’ … ‘A512’ ).

This setting is only relevant if the device is operating as Slave controlled by a Master, but not

via DMX. When the display shows the desired value press [OK] to conrm the selection and

then [M] to return to the parent menu. To return to the parent menu without making changes,

press [M].

Operating mode ‘Show/Master’

Operating mode ‘Slave’

Operating

LED oodlight