User manual

Press [M]. Press one of the arrow buttons repeatedly until the display shows ‘SET’ . Press [OK].

Press one of the arrow buttons repeatedly until the display shows ‘MIC’ . Press [OK]. Now you

can adjust the sensitivity of the built-in microphone for sound control. Use the arrow buttons

to select either ‘OFF’ (microphone o) or a value between 1 and 30 (display shows ‘M-01’ …

‘M-30’ ).

This setting is only relevant if the device is not controlled via DMX. When the display shows the

desired value press [OK] to conrm the selection and then [M] to return to the parent menu. To

return to the parent menu without making changes, press [M].

Press [M]. Press one of the arrow buttons repeatedly until the display shows ‘TEST’ . Press [OK].

Press one of the arrow buttons repeatedly until the display shows ‘RED’ , ‘GREE’ , ‘BLUE’ , ‘WHIT’

or ‘STRO’ . Press [OK]. Now you can set the brightness of the red, green, blue or white LEDs

each in a range from 0 to 255, or select the strobe rate in a range of 0 to 24.

This mode is also suitable for generating constant or ashing light of a colour mixed from the

four LED colours without DMX control.

When the display shows the desired value press [OK] to conrm the selection and then [M] to

return to the parent menu. To return to the parent menu without making changes, press [M].

Microphone sensitivity

Manual test

Operating

LED oodlight