User's Manual

ASSEMBLY INSTRUCTIONS

STEP 12

Hook a PULLEY SET(29) to one of the hooks on the end of the CROSSING BAR(7). Run the Eyelet End

of the CABLE(28), 3980mm (156.7”) long, through the PULLEY SET(29).

Run the Eyelet End of the CABLE(28) through another PULLEY SET(29). Hook the PULLEY SET(29) to

the hook on the BASE FRAME(1).

Attach the CABLE(28) to the Bracket on the LEFT FORCE ARM(9) with a PULLEY(23), a PULLEY

COVER(74), a BUTTON HEAD BOLT(M8x1.25x80mm)(57), a WASHER(M8)(69), and a NYLOCK NUT

(M8x1.25)(67).

Attach the CABLE(28) to the LOWER UPRIGHT(3) with a PULLEY(23), a CABLE GUIDE(27), a

BUTTON HEAD BOLT(M8x1.25x90mm)(58), two WASHERS(M8)(69), and a NYLOCK NUT(M8x1.25)

(67).

Connect the CABLE(28) to the LAT BAR CABLE(25) with the SMALL QUICK LINK(40). Repeat all the

above assembly for the other side. Both the CABLES(28) are connected to the LAT BAR CABLE(25)

with the SMALL QUICK LINK(40). The inset drawing shown the cables after assembly at the back.