User's Manual

ASSEMBLY INSTRUCTIONS

STEP 16

Attach the LEG LIFT(12) to the SEAT FRAME(11) with BUTTON HEAD BOLT(M10x1.5x65mm)(63),

WASHERS(M10)(70), and NYLOCK NUT(M10x1.5)(68). Do not over tighten the bolt, as the LEG

LIFT(12) must be able to pivot smoothly.

STEP 17

Slide a FOAM PAD(15) onto a PAD TUBE(14) and screw a SECURING CAP(44) into the end of the PAD

TUBE(14). Then insert the other end of the PAD TUBE(14) through the hole in the SEAT FRAME(11).

Slide another FOAM PAD(15) over the protruding end of the PAD TUBE(14) and screw a SECURING

CAP(44) into the end of the PAD TUBE(14). Repeat to assemble the FOAM PADS(15) to one of the

adjustment holes in the LEG LIFT(12).

NOTE: The three adjustment holes in the LEG LIFT(12) allow the FOAM PADS(15) to be attached in

three different positions. Start with one of the center positions and adjust if necessary. Use the

upper position if users are shorter than average. Use the lower position if users are taller than

average.