- Stamina Products, Inc Stepper Machine User Manual

SET UP INSTRUCTIONS
Place the INSTRIDE PRO stepper in the area where it will be used. It is recommended that the INSTRIDE
PRO stepper be placed on an equipment mat. The max. operation dimensions of INSTRIDE PRO stepper
is approximately 17 3/8" long x 11 3/4" tall x 12 3/8" wide. (These dimensions may vary up to one inch.) An
area 6 feet wide x 6 feet long is required for safe operation of the INSTRIDE
PRO stepper. Make sure that
adequate space is available for access to and passage around the INSTRIDE
PRO stepper.
Make sure the INSTRIDE
PRO stepper is set solidly on the floor with no rocking.
Grasp the Front and Rear Stabilizers to move the INSTRIDE
PRO stepper. Do not use the
Pedal Arms to move the INSTRIDE
PRO stepper. The Pedal Arms will move and the
SHOCK(6) may pinch your hand or fingers.
LEVELING:
MOVING:
FUNCTION INSPECTION
NOTE: Always make sure that the CABLE(9) is
properly seated in the groove on the PULLEY(8) before
using the INSTRIDE
PRO stepper.
Visually inspect the INSTRIDE PRO stepper to verify
that assembly is as shown in the above illustrations.
Check the function of the INSTRIDE
PRO stepper.
Stand on the foot pedals and slowly move your highest
foot downward and follow the natural path of the
machine. The Shocks should provides resistance for
your workout.
6
Inspect the RESISTANCE TUBES(32, 33) for nicks and cuts. Replace damaged RESISTANCE TUBES
(32, 33).
Verify that the SHOCKS(6) provides resistance by pushing down on the foot pedals.
SHOCKS(6) on steppers get HOT during use. To avoid burns, do not touch the SHOCKS(6) until they
have time to cool.
Verify that the Warning Label is in place and easy to read. Call Stamina Products immediately
(1-800-375-7520) for a replacement Warning Label if the Warning Label is missing or damaged.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the INSTRIDE
PRO stepper removed
from service until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the INSTRIDE
PRO
stepper.
Keep your INSTRIDE
PRO stepper clean by wiping with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.
8.
The safety and integrity designed into the INSTRIDE
PRO stepper can only be maintained when the
INSTRIDE
PRO stepper is regularly examined for damage and wear. Special attention should be given to
the following:
MAINTENANCE
STORAGE
1.
2.
3.
4.
To store the INSTRIDE PRO stepper simply keep it in a clean dry place.
The minimum dimesions of INSTRIDE
PRO stepper is approximately 17 3/8" long x 8 1/4" tall x 12 3/8"
wide. These dimensions will vary. Please measure your INSTRIDE
PRO stepper if exact dimensions
are needed.
Grasp the Front and Rear Frame to move the INSTRIDE
PRO stepper. Do not use the Pedal Arms to
move the INSTRIDE PRO stepper.
To avoid damage to the electronics, remove the battery before storing the INSTRIDE
PRO stepper for
one year or more.