Owner's Manual

ASSEMBLY INSTRUCTIONS

To attach the HANDRAIL(9), position the HANDRAIL(9) under the SEAT CARRIAGE(7) as shown in the

above illustration and secure with BUTTON HEAD BOLTS(M8x1.25x45mm)(71), ARC WASHERS(M8)

(98), and LOCK WASHERS(M8)(100).

STEP 8

Refer to the inset drawing. Plug the PULSE SENSOR WIRE(55) into the SOCKET of the PULSE EXTENSION

WIRE(43) located on the SEAT RAIL(45).

STEP 7

NOTE:

The PULSE SENSOR WIRES(55) go through the tube of the HANDRAIL(9). Be careful not to

damage the wires with the BUTTON HEAD BOLTS(M8x1.25x45mm)(71) when attaching the

HANDRAIL(9) to the SEAT CARRIAGE(7).

Socket of Pulse

Extension Wire(43)

STEP 6

Attach the SEAT FRAME(114) to the SEAT CARRIAGE(7) with BUTTON HEAD BOLTS(M10x1.5x200mm)

(76), WASHERS(M10)(99), LOCK WASHERS(M10)(101), and ACORN NUTS(M10x1.5)(97).

NOTE:

Use this set of attachment

holes for assembly.

The four attachment holes on each side of the SEAT FRAME(114) allow the SEAT FRAME(114) to

be attached in two different positions: one to position you closer to the HANDLEBAR(4) and one

further away. At this point of assembly, use the holes at the back so the Seat Assembly is closer to

the HANDLEBAR(4). After all assembly steps, refer to page 14 for the details of seat adjustment.