Owners Manual

4 feet

6 feet

Place the STAMINA® Cycling Workstation in the area where it will be used. It is recommended that

the STAMINA® Cycling Workstation be placed on an equipment mat. The STAMINA® Cycling

Workstation is approximately 45.1 inches long x 25.2 inches wide x 46.8 inches tall. (These dimensions

may vary up to one inch.) An area 4 feet wide x 6 feet long is required for safe operation of the

STAMINA® Cycling Workstation. Make sure that adequate space is available for access to and

passage around the STAMINA® Cycling Workstation.

LEVELING: Adjust the location of STAMINA® Cycling Workstation so the bike sits on the oor without

rocking.

MOVING: The STAMINA® Cycling Workstation has a pair of WHEELS(31) on the REAR

STABILIZER(9). Hold the HANDRAIL(8) and tilt back on WHEELS(31) to move the

STAMINA® Cycling Workstation.

FUNCTION INSPECTION:

Visually inspect the STAMINA® Cycling Workstation to verify that assembly is as shown in the above

illustration. Check the function of the STAMINA® Cycling Workstation by turning the crank slowly

through one complete revolution to verify that the drive train functions properly. Adjust the TENSION

KNOB(58) and verify that it functions properly and the resistance changes.

CAUTION: Locate and read the CAUTION LABEL(105) on the STAMINA® Cycling Workstation. Make

sure that all users read the CAUTION LABEL(105) before using the product.

SET UP INSTRUCTIONS

Equipment Mat

(not included)