Instructions / Assembly

LOAD ADJUSTMENT

The resistance of the shock can be adjusted by twisting the adjustment

knob at the top of the shock. There are settings from 1 to 12. Setting #1

will provide the lowest resistance. Setting #12 will provide the highest

resistance.

CAUTION: The shock gets HOT after a few minutes of use.

Adjustment

Knob

Mark

OPERATIONAL INSTRUCTIONS

The safety and integrity designed into the BodyTrac

Glider can only be maintained when the

BodyTrac

Glider is regularly examined for damage and wear. Special attention should be given to the

following:

1. Pull on the HANDLEBARS(17, 18) and verify that the SHOCK(22) provides tension.

2. Clean the roller tracks in the CENTER BEAM(1) with an absorbent cloth.

3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.

Tighten loose nuts and bolts.

4. Verify that the WARNING LABEL(67) is in place and easy to read. Call Stamina Products immediately

at 1-800-375-7520 for a replacement WARNING LABEL(67) if it is missing or damaged.

5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

6. Worn or damaged components shall be replaced immediately or the BodyTrac

Glider removed

from service until repair is made.

7. Only Stamina Products supplied components shall be used to maintain/repair the BodyTrac

Glider.

8. Keep your BodyTrac

Glider clean by wiping it off with an absorbent cloth after use.

MAINTENANCE

PEDAL STRAP ADJUSTMENT

If you feel it is more comfortable for your workout, you can change to attach the PEDAL STRAP(35) to the

upper position in the PEDAL(34) as shown in illustration 1 below. Run the PEDAL STRAP(35) through the

opening from the bottom of the PEDAL(34), then go through the Steel Ring. Slide the Steel Ring down to

against the PEDAL(34). Run the PEDAL STRAP(35) through the opening in the PEDAL(34) on the other

side from the top as shown in the illustration 1, then make the end of the PEDAL STRAP(35) go up to

attach onto the upper part of the PEDAL STRAP(35) with the Hook & Loop Pad.

Attach the end of the PEDAL STRAP(35) to different position with the Hook & Loop Pad to adjust the length.

Refer to illustration 2.

Hook & Loop Pad

Steel Ring

1. 2.

End of Pedal Strap