Instructions / Assembly

The safety and integrity designed into the ATS Air Rower 1402 can only be maintained when the ATS

Air Rower 1402 is regularly examined for damage and wear. Special attention should be given to the

following:

1. Sit on the SEAT(9) and pull on the HANDLEBAR(16) to verify that the Fan System provides resistance

and the seat travel is smooth and stable.

2. Clean the roller tracks on the RAIL(8) with an absorbent cloth.

3. Verify that the CAUTION LABEL(116) is in place and easy to read. Call Stamina Products immediately

at 1-800-375-7520 for a replacement CAUTION LABEL(116) if it is missing or damaged.

4. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

5. Worn or damaged components shall be replaced immediately or the ATS Air Rower 1402 removed from

service until repair is made.

6. Only Stamina Products supplied components shall be used to maintain/repair the ATS Air Rower 1402.

7. Keep your ATS Air Rower 1402 clean by wiping it off with an absorbent cloth after use.

STORAGE

MAINTENANCE

Lifting the

RAIL(8) slightly

1. To store the ATS Air Rower 1402, simply keep it in a clean dry place.

2. To avoid damage to the electronics, remove the batteries before storing the ATS Air Rower 1402 for

one year or more.

3. Move the ATS Air Rower 1402 with the moving wheels on the FRONT STABILIZER(6). Grasp and lift

the REAR STAND(5) to move the ATS Air Rower 1402. Do not use the SEAT(9) to move the ATS Air

Rower 1402. The SEAT(9) will move and the SEAT CARRIAGE(22) may pinch your hand or ngers.

4. Follow this process as described and illustrated to fold the ATS Air Rower 1402 for easy storage.

a. Remove the PULL PIN(54), LOCKING KNOB(53), and WASHER

(ø13xø28x2mm thick)(55)

from the

ATS Air Rower 1402.

NOTE: Lifting the RAIL(8) slightly will make it easier to remove the PULL PIN(54).

b. Refer to illustration B. Fold the RAIL(8) upward. Secure the RAIL(8) in folded position by inserting

the PULL PIN(54) into the MAIN FRAME(1).

c. Slide the WASHER(55) onto the LOCKING KNOB(53). Insert the LOCKING KNOB(53) into the

MAIN FRAME(1) for storage.

A. B.