Instructions / Assembly

ASSEMBLY INSTRUCTIONS
7
NOTE: There are some packing parts attached on the ATS Air Rower 1402. Please follow the steps
below to remove them before any assembly. These parts are only for packing, do not dispose of
the packing materials until assembly is completed.
STEP 1
Remove the CARDBOARD ROLLER from the front of the MAIN FRAME(1) by removing the SCREWS
and WASHERS.
STEP 2
A BUCKLE has been attached to the STRAP(24) to prevent the STRAP(24) from returning into the main
body of the ATS Air Rower 1402 during shipping. Remove the BUCKLE by following these steps:
1. Refer to detail view 1. Pull the STRAP(24) away from the main body about 8 inches. Use one hand to
hold the STRAP(24) at position A while using the other hand to pull the STRAP(24) loop on the top of
the BUCKLE to the position as shown in detail view 2.
2. Refer to detail view 2. Continue to hold the STRAP(24) at position A. Pull the STRAP(24) from
position B until the STRAP(24) is completely removed from the BUCKLE. Make sure the STRAP(24)
isn't twisted and let it return into the main body of the ATS Air Rower 1402. The STRAP(24) will hold
the HANDLEBAR(16) taut against the MAIN FRAME(1).
1.
2.
Cardboard Roller
A
B
Buckle
Buckle
Buckle
Screws
Washers
A
Place all parts from the box in a cleared area and position them on the oor in front of you. Remove
all packing materials from your area and place them back into the box. Do not dispose of the packing
materials until assembly is completed. Read each step carefully before beginning. If you are missing
a part, please go to staminaproducts.com under the Service section and order the part needed,
e-mail us at [e-mail], or call us toll free at 1-800-375-7520 (in the U.S.).
Our Customer Care Staff is available to assist you from 7:30 A.M. to 5:00 P.M. (Central Time) Monday
through Thursday and 8:00 A.M. to 3:00 P.M. (Central Time) on Friday.