Instructions / Assembly

ASSEMBLY INSTRUCTIONS
7
Wire Ring
2.
1.
STEP 1
Lay the trampoline on the oor. The trampoline will appear as shown in illustration 1.
To unfold the STAMINA® Oval Jogger to the at position, hold the SEMICIRCLE RAILS(2) and push the
rails down at the same time. The SEMICIRCLE RAILS(2) and RAILS(1) should snap together and be locked
by the SECURE PINS(9) when you reach the at position. Refer to illustration 2.
Hazard label on trampoline surface reads as follows:
!
WARNING!
PREVENT serious INJURY or DEATH.
Rails can SPRING back and STRIKE someone.
ALWAYS fold and unfold carefully with TWO or
more STRONG people.
Do NOT remove this tag.
ALWAYS USE TWO OR MORE STRONG PEOPLE TO UNFOLD OR FOLD THE
STAMINA® Oval Jogger. FAILURE TO USE TWO OR MORE STRONG PEOPLE
MAY ALLOW THE RAILS TO SPRING BACK INTO THE FOLDED POSITION AND
STRIKE SOMEONE WHICH CAN CAUSE SERIOUS BODILY INJURY OR DEATH.
Keep ngers away from the ends of the rails in the hinge area when unfolding the
STAMINA® Oval Jogger. Serious injury can occur if ngers are caught between the
ends of the RAILS.
STOP!
STEP 2
NOTE: Make sure the SECURE PINS(9) are inserted into the ends of RAILS(1, 2) and properly secured
by the Wire Ring. Both ends of the SECURE PINS(9) should have approximately 1/8 inch between
the RAILS(1, 2) and the Wire Ring. Refer to illustration 2.
!
WARNING