Instructions / Assembly

ASSEMBLY INSTRUCTIONS

4.3.

STEP 3

Slide the SAFETY PAD(4) over the rail frame. Make sure the holes in SAFETY PAD(4) t over the threaded

connectors properly. Refer to illustration 3.

HINT

: Install one hole over a threaded connector. The next hole installed should be on the connector on

the opposite side of the trampoline.

STEP 4

Remove the Plastic Caps from the threaded connectors. Screw the LEGS(5) onto the threaded connectors

on the rail frame.

First step,

install the Safety Pad(4)

on this end being sure

the hole ts over the

threaded connector.

B. Second step, install the

Safety Pad(4) on the opposite

end being sure the hole ts over

the threaded connector.

Threaded

Connector

STEP 5

Place the trampoline in the normal use position. Remove the LEG CAPS(7) from the two LEGS(5) as

shown in illustration 5. Slide the HANDRAIL SUPPORTS(16) onto the LEGS(5). Press the LEG CAPS(7)

back on the LEGS(5).

Remove all of the

eight Plastic Caps from the

threaded connectors before

installing the LEGS(5).