Owner's Manual

OPERATIONAL INSTRUCTIONS
WALKING RESISTANCE
The walking resistance or effort needed to push the treadmill belt can be adjusted by changing the incline
angle. This treadmill has two adjustment positions.
Lowest Resistance
Remove (unscrew) the BUMPER STANDS(17)
from the bottom of the treadmill and store them
in the end of the treadmill.
Highest Resistance
The BUMPER STANDS(17) are attached to
the bottom of the treadmill.
NOTE:
The safety and integrity designed into the inMotion® T900 Treadmill can only be maintained when the
inMotion® T900 Treadmill is regularly examined for damage and wear. Special attention should be
given to the following:
MAINTENANCE
12
1. Since this is a new machine, you may need some time to get used to walking on the treadmill and to
break it in.
2. If the walking resistance is still too high, check the BELT TENSION. Refer to page 11 for instructions to
adjust belt tension.
3. The belt resistance can be reduced by adding silicone lubricant between the belt and the board. Wipe
the board under the belt with a clean, dry cloth then spray or spread silicone lubricant on the board
under the belt
.
1. Clean the exposed surfaces of the walking belt and the board with an absorbent cloth.
2. Verify that the LOCKING KNOB(5) is present and functioning properly. Repair or replace parts as
necessary.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the CAUTION LABEL(52) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(52) if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately or the inMotion® T900 Treadmill
removed from service until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the inMotion® T900
Treadmill.
8. Keep your inMotion® T900 Treadmill clean by wiping it off with an absorbent cloth after use.
9. If the WALKING BELT(14) does not move easily, lubricate the BOARD(15) under the WALKING
BELT(14) with silicone lubricant.