Owners Manual

The TOTAL DIST will be reset to zero after batteries are removed for battery replacement or storage
of the unit.
POWER OFF:
Walking Belt movement or press
any button.
Automatically shuts off after 4
minutes of inactivity.
POWER ON:
USING THE FITNESS METER
FUNCTIONS:
FUNCTION BUTTONS:
RESET :
This button will reset each function to zero.
To reset all functions to zero, press the button and hold it down for three seconds, except TOTAL DIST.
SET :
Press to set target values for TIME, DISTANCE, and CALORIES.
MODE :
Press and release to select each function for display or preset target values.
Press the button and hold it down for three seconds to reset all functions to zero, except TOTAL DIST.
1. Open the Battery Door on the back of the meter.
2. The meter operates with two AA batteries, the batteries are not included.
Refer to the illustration to install or replace the batteries.
HOW TO INSTALL AND REPLACE BATTERIES:
11
AA Batteries
OPERATIONAL INSTRUCTIONS
set
reset
mode
scan
time
speed
distance
calories
total dist
pulse
PRESET VALUES OPERATION:
Stop walking for four seconds. Press the MODE button to select functions for preset target values. The meter will
cycle through the functions as follows and allow you to set the function values.
TIME (0:00 to 99:00)
DISTANCE (0.0 to 999.0 mile) CALORIES (0.0 to 999.0 Kcal)
Use SET & RESET buttons to enter desired values and press MODE button to conrm and move to next function
for presetting. To pass the setting of some functions, just press the MODE button. Start to run the Meter functions by
walking.
Automatically scans TIME, SPEED, DISTANCE, CALORIES, TOTAL DIST, and PULSE in sequence
with a change every six seconds.
Counts upward to 99:59 in one second increments. Counts down from preset value.
Displays the current speed from zero to 999.9 Mile/Hr.
Displays distance up to 999.9 miles in increments of 0.01 miles. Counts down from preset value.
Displays the calories burned from zero to 999.9 Kcal. Counts down from preset value.
The calories readout is an estimate for an average user. It should be used only as a comparison
between workouts on this unit.
Displays the total accumulated distance you have taken from zero to 9999 miles. The total
accumulated distance is retained when the meter is turned o󰀨.
Displays your pulse rate in beats per minute. To display pulse, select the PULSE mode and grasp
the pulse sensors on the handrails, one in each hand. The heart icon will begin ashing when the
electronic meter senses your pulse. Your pulse will be displayed approximately ve (5) seconds after
the heart icon is displayed. If the heart icon does not appear, relax your grip or change your grip on
the pulse sensors.
NOTE: The pulse function is a great tool to optimize your workout, but should be used as a reference only.
NOTE:
SCAN:
TIME:
SPEED:
DISTANCE:
CALORIES:
TOTAL DIST:
PULSE:
1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
3. Rechargeable batteries are not recommended.
4. Ultimate disposal of battery should be handled according to
all state and federal laws and regulations.
5. Do not dispose of batteries in re.
NOTE: