Owners manual

SIDEWIND DEFLECTOR
INSTALLATION and CLEANING
SIDEWIND DEFLECTOR
INSTALLATION and CLEANING
I - Sheet Number STMPD01 Rev.A
I - Sheet Number STMPD01 Rev.A
Stampede Automotive Products • Visit us at stampedeproducts.com • 800-241-7219
Stampede Automotive Products • Visit us at stampedeproducts.com • 800-241-7219
IMPORTANT: Clean with a SOFT cloth and soap and water ONLY! Using abrasive cleaners, chemicals, or solvents will VOID the warranty on this product.
IMPORTANT: Clean with a SOFT cloth and soap and water ONLY! Using abrasive cleaners, chemicals, or solvents will VOID the warranty on this product.
A
A
A
A
B
B
B
B
C
C
C
C
D
D
D
D
70°-100° F (Install temp.)
70°-100° F (Install temp.)
1
1
2
2
3
3
4
4
5
5
Clean rubber, black, or chrome trim and mirror cap with alcohol pad where visor will attach. If Scotch Brite scuff pad
included scuff rubber trim.
Remove tape liner from front and rear flanges and peel back 2” from each end of top flange.
Align/Attach front flange to mirror cap. (Front end flange may overlap mirror cap depending on vehicle style.) Align top and
rear flanges to trim.
Remove tape liner by pulling on free ends. Apply presure to flanges to secure and ensure adhesion to trim surface.
The rear visor attaches with the same preparation methods as the front visor.
Clean rubber, black, or chrome trim and mirror cap with alcohol pad where visor will attach. If Scotch Brite scuff pad
included scuff rubber trim.
Remove tape liner from front and rear flanges and peel back 2” from each end of top flange.
Align/Attach front flange to mirror cap. (Front end flange may overlap mirror cap depending on vehicle style.) Align top and
rear flanges to trim.
Remove tape liner by pulling on free ends. Apply presure to flanges to secure and ensure adhesion to trim surface.
The rear visor attaches with the same preparation methods as the front visor.