User Manual

UpTrak Metro Sit/Stand Desk
Made in China
www.standsteady.com
[e-mail]
1-703-688-DESK (3375)
Components Included:
1 Desktop Level
1 Base
2 Rails
1 Rail Cap
Directions
1. Insert the Rails:
- Insert the rails, with the side with less
holes pointed down (Rails are treated to
make top slide easily, if rails are “oily”
simply dry with paper towel)
- Holes must point out at the angle in the
photo to align with desktop level
- Screw rails into the base but
DO NOT fully tighten screws
2. Add the Desktop Panel:
Screw any taped on hooks into the
nearby holes. Place the desktop level
onto Rails and fully lower.
3. Align Rails:
Turn rails until holes line up with
locking pins. Turn locking pin up and
slide desktop level up until the pins
enter the first hole.
4. Add the Rail Cap:
Place Rail Cap onto rails and screw
on. Then fully tighten screws on the
bottom of the desk.
5. Screw in Pulley Wheels:
- Remove nut from wheel
- Insert wheel into rail cap; wheels
face out
- Screw nut back on
6. Raise Desktop Level:
Move Desktop Level to top hole. Pull
back locking pins and slide up.
Release pins to slide into holes.
7. Attach Spring:
A. Attach spring to hook on base level.
B. Insert spring through hole in the
desktop level. C. Hook spring to the
desktop level. D. Pull spring over
wheel.
Troubleshooting:
Pin Alignment
If pins do not align with the holes in the
rail, loosen the screws on the rail cap and
the bottom of the desk to rotate the rail to
align with the pin.
Troubleshooting:
Desk Level Not Sliding Down
If desktop level does not easily slide
down, use two nger and apply light up
lifting pressure to the front edge of the
desk while it is lowering.
UPTRAKKTBL / UPTRAKKTBR / UPTRAKKTWH
B
C
A
D
2 Springs
2 Pulley Wheels
4 Screws
2 Hooks
1 Screwdriver
*Warning: Assemble on top of the cardboard box so screws don’t scratch your existing desk*