User Manual

GX1600/GX1700
Page 24
2. Install the ferrite core (supplied with the RAM3+
(
CMP31
)
Remote
Station Microphone) to the extension cable, then snap its two halves
together, per the illustration on the next page.
3. Attach the ferrite core as close as possible to the MIC plug, as shown
below.
4. Finally, wind some plastic tape
around each ferrite core, to
prevent vibration from causing
the two halves to split apart.
As close as possible
Routing Cable or
CT-100 Extension Cable
Ferrite Core
Snap together
External Speaker
Connections
5. Referring to illustration below, make a 1.2” (30 mm) hole in the wall, then
insert the extension cable into this hole. Connect the gasket and mount
base to the extension cable connector using the nut.
6. Drill the four screw holes (approx. 2 mm) on the wall, then install the
mounting base to the wall using four screws.
7. Put the rubber cap on to the nut. The installation is now complete.
Wall
Gasket
Mounting Bracket
Routing Cable
Cap
Nut
External Speaker Connections
Ferrite Core
NOTE
The routing cable can be cut and spliced, however care needs to be
taken when reconnecting the wires to ensure water integrity.
Before cutting the cable make sure it is not plugged into the radio.
After cutting you will notice there are the following wires:
Brown, Gray, Blue, Green, White

, Shield


The white and shield wires are wrapped in foil. Remove the foil,
and separate the white and shield wires.