User Manual

Page 25HX400
6.9 PRIORITY SCAN
The Priority Scan is similar to the Memory Scan. However, the Priority Scan
monitors the Preset Channels, Scan Memory Channels and the Priority Chan-
nel. The following channels can be set as the Priority channel: CH16, CH9, or
one of the Preset channel (default setting is CH16).
1. To set the priority channel, hold down the key and press the
key. The channel will change from 16 to 09 to Pre-
set channels 0 through 9 with each press of the
key. When the key is released the displayed chan-
nel will be set as the priority channel (the “PRI” icon will
appear above of the channel number).
2. Press the key to start Scanning.
3. Press and hold the key to start Priority Scan, “PSCAN” will be shown on
the display.
4. When the HX400 receives a transmission on a work-
ing channel, it will stop on the working channel and
dual watch to the priority channel until the incoming
signal disappears, then start scanning again.
5. When the HX400 receives a signal on the Priority channel it will stay on
this channel until the incoming signal disappears, then
start Priority scanning again.
6. To stop Priority Scanning, press the key.
Preset
Channel “0”
Preset
Channel “5”
Preset
Channel “4”
Preset
Channel “1”
Preset
Channel “2”
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Preset
Channel “3”
“PRIORITY” SCAN
“MEMORY” SCAN
Preset
Channel “0”
Preset
Channel “5”
Preset
Channel “4”
Preset
Channel “1”
Preset
Channel “2”
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Preset
Channel “3”