User Manual

HX400IS
Page 10
4. GETTING STARTED
4.1 RADIO CARE
CAUTION
Before following the instructions below, insure the battery pack is
in place and rmly connected. Care must be taken if the radio was
dropped and a close inspection may be needed to insure the radio
case and gaskets are in adequate condition.
The design of the HX400IS allows water to enter between the radio and the
battery pack, however waterproof performance is not compromised.
After using the HX400IS in salt water environment is recommended to clean
the radio with fresh water by rinsing the battery and radio (separately) under
a sink facet or by dunking in a fresh water. After washing,use a soft cloth to
thoroughly dry all parts of the radio and battery.
This will keep the radio parts and the battery clean and in top operating con-
dition.
4.2 BELT CLIP INSTALLATION AND REMOVAL

To install the Belt Clip: align the
Belt Clip to the groove of the
Battery pack, then press the Belt
Clip downward until it locks in
place with a “Click.”

To remove the Belt Clip: press
the Belt Clip Tab away from the
battery pack to unlock the Belt
Clip, then slide the Belt Clip up-
ward to remove it.


Belt Clip Tab