User Manual

Page 13
HX400IS
4.3.3 BATTERY CHARGING
1. Turn the transceiver off.
2. Insert the DC plug from the PA-45B
into the DC jack on the CD-50 side
panel, then plug the PA-45B into the
AC line outlet.
3. Insert the HX400IS (with the battery
pack) into the CD-50; the antenna
should be at the left side when viewing
the charger from the front.
4.
If the HX400IS is inserted correctly, the
Red “CHARGING” indicator will glow.
A fully-discharged pack will be charged
completely in approximately 3 hours.
5. When charging is completed, the red
LED indicator will change to green. Remove the transceiver from the CD-
50, and unplug the PA-45B from the AC line outlet.
NOTE: The green LED indicator may blink after charging is complete,
but this is not a malfunction.
WARNING

Do not reverse-connect the battery terminals.

Do not parallel-connect the battery terminals.

Do not change batteries in hazardous locations.

To reduce the risk of explosion, recharge the batteries outside of
hazardous locations.

If the LED blinks red, please insert the HX400IS again. If LED
continues blinking red, the CD-50 Desktop Charger or the battery
may be defective. Disconnect the HX400IS from the CD-50, then
please contact Standard Horizon/Yaesu authorized dealers.
CAUTION
The CD-50 cradle is NOT designed to be waterproof. Do not attempt
to charge in water hazardous locations.
NOTE
The CD-50 cradle is only designed for the charging of the HX400IS’s
battery, and is not suitable for other purposes. The CD-50 may contrib-
ute noise to TV and radio reception in the immediate vicinity, so we do
not recommend its use adjacent to such device.
PA-45B
CD-50