User Manual

HX400IS
Page 22
6.8 MEMORY SCAN
The HX400IS will automatically scan channels programmed into Preset
Channel Memory and also channels store into Scan Memory.
When an incoming signal is detected on one of the channels during scan, the
radio will pause on that channel, allowing you to listen to the incoming trans-
mission. The radio will automatically start scanning again after the transmis-
sion stops.
6.8.1 PROGRAMMING SCAN MEMORY
1. Turn the transceiver off by rotating the VOL knob fully counter-clockwise.
2. Hold down the
key, and then turn on the transceiver while still hold-
ing down the key.
3. Press the or key to select “
MEM CH
” and press
the key.
4. Press the or key to select desired channel to
be scanned, then press the key. The “ ” icon
appears on the display, which indicates the channel
has been selected to the scan channel.
5. Repeat step 4 for all the desired channels to be pro-
grammed into scan memory.
6. To DELETE a channel from the list, select the chan-
nel then press the key. The “ ” icon disappears
from the display.
7. When you have completed programming the scan
memory, press the key to save your changes,
and then press the key to exit to normal operation.
6.8.2 OPERATION
1. Press the key to activate the squelch adjusting mode, then press the
or key until the background noise disappears.
2. Press the key to start scanning channels pro-
grammed into memory and preset channels. “
MSCAN
”
will be shown in the upper left corner of the display.
3. When the HX400IS receives a transmission, it will
stop on the channel until the incoming signal disap-
pears, then start scanning again.
4. To stop scanning, press the key.